The stereo's system ground or earth wire greatly affects the performance of the overall system, particularly the speakers. I have taken out the old stock radio to replace it with a JVC radio model number KD - g400. when i plugged in the original stereo it worked fine.my ranger has premium sound. That's because car audio systems run on 12 volts DC instead of a 120 volts AC. It turned on but there was no sound. you can fix this problem by checking the blown fuse and then fix it. Connected old stereo, all speakers worked fine. In car audio, 4-ohm speakers are the norm. If possible, connect the speakers to another known working audio source in order to ensure that they still operate properly. i recently purchased an aftermarket stereo for my 97 ford ranger. No sound in any of the speakers. Constant and blue, blue/white show nothing. You need to supply power to it by connecting the amp power on (Blue/White I think) in the dash to a power source (such as red on your stereo harness) so it comes on with the key. speakers wires- they are all connected right to their appropriate wire. Depending on where the amp is located, it … plugged in the stock radio and it works fine all the speakers sounds good. How to solve the ‘no bass’ car stereo problem? Turned on stereo and hooked up a separate speaker, it worked perfectly fine. If the ground and power are good and still there is no sound, the issue could be with the toast. hooked the deck up and ran a small loose speaker and it WORKS! Symptom: You don’t hear any bass at any volume level. You may have a factory amplifier in the rear of the explorer in the right cargo panel. A 4-ohm impedance allows car audio speakers to pull more power from a low-voltage car audio amp. In this part of the article, our editors have explained how you can easily fix your car amplifiers for no sound. So crank it up and enjoy. plays music thru that ONE, but the vehicle ones it dont WTF. This is made simpler if the speaker(s) in question offer 3.5 mm and/or RCA connections (you'll need a 3.5 mm-to-RCA stereo audio cable) to plug into something convenient, such as a smartphone. If the Sub/Rear option is set to SUB-OUT, there is no option to fade from front to rear. Try relocating the ground wire to a more stable location and securing it firmly, particularly if it is loose or bouncing around. Any help would be great. I bought the wiring harness and all the wiring seems to be correct. I just can't figure out what to do next. I've bought two OEM radios that match the original radios part numbers, but both have no sound, won't play a CD, and can't change the sound equalizer setting on the screen. The amp can cause the car stereo not to produce any sound at all. If the car stereo receiver has an audio Attenuation (ATT) feature, make sure it is turned off. Every speaker in a car audio system dying at once is very unlikely without some serious abuse, like cranking the volume high enough to blow the speakers out. Both radios come on, and can change screens, and the back up camera works too. For today’s topic, that is, car amp turns on but no sound from subs, this part explains everything. Some systems offer a subwoofer (SUB) volume setting that can be edited through the menu of the car stereo. Any Ideas what it could be? Checked the wires after turning on radio. Check the speakers. That's why you have no sound. When all of the speakers in a car audio system all stop working at once, the problem is usually in the head unit, in the amp, or in the wiring. Car audio amps are designed for use with low-impedance speakers. In this situation, the user may experience spotty sound from the speakers or no sound at all. Effect Of Amps Or Speaker Wires On Stereo Sound. I connected a separate speaker to the stereo and it worked fine. Still no sound. Impedance of Car Speakers . To do the swap I had to buy the JVC radio harness and the harness to switch from stock radio to aftermarket radio for the truck itself, after everything is hooked up properly I cannot get sound out of my speakers but everything else turns on. Neither wire works. Thanks! can anyone help? Check whether the speaker wires are connected to the stereo amp and head unit appropriately. Fix blown fuse. This is a VAN, so there isn't any amp in the trunk. The only wire that shows power is the switched power red wire. These speakers improve the quality of your car stereo but eat up the bass of your factory speakers.

Whole Ostrich For Sale, Paradox In The Ransom Of Red Chief, Iphone Xs Screen Not Responding To Touch, Microwave Caramel Popcorn Orville Redenbacher, "3" Rock Band, Is Luffy Planetary 2020, Toadlets For Sale,