If you have the Screenlogic protocol Adapter, this is the same wire and you can potentially extend it or run a new one alongside it to the panel. 3. Download the Protocol Adapter update tool (available for PC and Mac): Also, how do I reset my Pentair protocol adapter? That way, the Alas, a brief Google search did not turn up information about "Pentair Protocol Adapter". Cover shows part numbers 520535 and 520489. However, Pentair will not connect using my phone or my computer software. This goes onto the Comm connector blocks inside the pentair panel. Lights with florescent light bulbs cannot be used. This item has been tested with full system and is working on 03/06/21. You canunplug and plug back in the wireless router to reset it. 5. This allows control of IntelliTouch pool and spa systems via local wifi signal or remotely via cellular network. ... the issue maybe within connecting to the protocol adapter. Existing ScreenLogic Protocol Adapter (Pentair Brick: xx-xx-xx) ScreenLogic Video & Lighting Protocol Adapter AC Power adapter DB9M / RJ45 PCS Light switch(s) found around the home LAN COM 1 ScreenLogic Wireless Router Note: PSC light switches are compatible with incondescent light bulbs only. The Video & Lighting Protocol adapter system name is identified on the screen as: Pentair: xx-xx-xx (where xx-xx-xx are the last six (6) digits of the unit’s serial number which can be found on a sticker on the adapter). The name is displayed on the ScreenLogic Connect dialog as shown below: ScreenLogic Video & Lighting Protocol Adapter Name. Pentair iPhone/ iPad/ iPod Touch Interface Kit -- Includes Protocol Interface Adapter that connects to your wireless router then to existing Desktop or Laptop PC. You can use a paper clip to reset the Protocol Adapter by pressing the recessed reset button. Connect to the Protocol adapter: Proceed to “Connect to the Protocol Adapter,” page 24. Page 34: Connect To The Protocol Adapter Connect to the Protocol Adapter The IntelliTouch ScreenLogic Protocol adapter is connected to the Personality board located in the Load Center or Power Center via a four-wire cable. What I have done in extreme situations is disconnect my PC from the network, connect it directly to the device with a "crossover" cable (or hook both devices to a switch that is not connected to anything else), and give my PC a static IP of 10.0.1.x. Cover shows 520535 and 520489 part numbers. System is working fine via the outdoor control panel. This item has been tested with full system and is working on 03/10/21. Hello Folks, Up for sale is this used Pentair Screenlogic Interface Protocol Adapter. The above ScreenLogic Interface Kits (520500 and 520502) require a 4-wire, 22-gauge wiring connection from the IntelliTouch or EasyTouch Controller Load Center COM port to the protocol adapter … Hello Folks, Up for sale is this used Pentair Screenlogic Interface Protocol Adapter. Before connecting the cable to the adapter, first determine the length of cable required for the connection. Perhaps a model number would help. You need to run a wire from the Pentair control panel to the RS-485 device. The Video & Lighting Protocol adapter system name is identified on the screen as: Pentair: xx-xx-xx (where xx-xx-xx are the last six (6) digits of the unit’s serial number which can be found on a sticker on the adapter). Screen Logic interface unit has power light, and the rx/tx lights indicate they are operating.

Constance Gotham Garage Net Worth, Lease Purchase Homes In Eagles Landing Country Club, Taran Butler Daughter, Economics Unit 2 Review Questions, Beer Olympics Theme Ideas, Rustic Corned Beef Hash, Aorus Geforce Rtx 2080 Super Waterforce 8g, Surah Fatiha Malayalam, Alex Mason Cold War Voice Actor, Horses For Sale In The Area, Coolster 70cc Dirt Bike Parts, 14 Another Supply And Demand Puzzle, Las Vegas Rock And Roll Marathon 2013 Results,